2~18MHz, Power gain43dB, Output Psat43dBm, SMA
To check stock availability, search under "In-stock Products" on the Dianzibuy store.
Any change to the content of this page is subject to change without notice. Please confirm the specifications before ordering.
Products must not be used for any unlawful purpose; the customer bears any loss arising from unlawful use.
Broadband microwave solid-state power amplifier, featuring miniaturization, high efficiency, and high reliability.
| Parameters | Min | Typical | Max | Units |
|---|---|---|---|---|
| Frequency | 2 | ~ | 18 | MHz |
| Power gain | 43 | dB | ||
| VSWR | 2 | |||
| Output Psat | 43 | dBm | ||
| Max input power | 10 | dBm | ||
| Spur reduction | 60 | dBc | ||
| 2nd harmonic Rejection | 10 | dBc |
| Connector | SMA-F or K |
| Impedance | 50Ω |
| Working voltage | +28V |
| Static operating current | 2.3A |
| Working current | 6A |
| Operation Temp. | -40~+60℃ Design assurance |
| Storage Temp. | -55~+85℃ Design assurance |
| Fan power supply | Power plug 220V (50Hz) |
| No. | definition | Note |
|---|---|---|
| 1~5 | +28VDC | |
| 6~10 | GND | |
| 11 | EN | High efficiency (3.3V) |
| 12 | Current reporting | |
| 13 | Temperature reporting | |
| 14 | Overvoltage and undervoltage alarm | High-voltage alarm (3.6V) |
| 15 | Coupling power reporting |
Fan plug (220V, 50Hz) →+28V → EN (+3.3V) → RF signal
Other frequency VSWR
Note: Changing the work sequence arbitrarily may pose a risk of burning the product.
Note: Exceeding any one or multiple maximum rated values may cause permanent damage to the module. Operating near the maximum rated values for extended periods may reduce the reliability of the module.
| Parameters | Maximum Rating | Test conditions |
|---|---|---|
| Power | +10dBm | Continuous wave, 50 Ω, 25 ℃ |
| Load SWR | 5.00 | 25℃ |
| Working voltage Vd | +40V | 25℃ |
| Heat consumption Pdiss | 140W | 25℃ |
Store in an environment with humidity less than 25%, pay attention to dust and static electricity prevention;
Good grounding, module ground, power ground, signal ground, equipment ground, and earth must be connected together;
Please pay attention to the power consumption of the product and consider the issue of amplifier heat dissipation during design;
The output signal cannot be left floating. Please connect it to a load, and ensure that the standing wave ratio (SWR) of the load is better than 5:1;
The input signal must not exceed 10dBm.
Please connect the attenuator to the module output before connecting it to the instrument. It is recommended to choose attenuators with frequencies ranging from 2 to 18GHz, attenuation values of 40dB, and attenuators above 30W.
Clean the surface of the product, do not soak the product in cleaning solution for cleaning.
Send us your requirements — our engineers will respond within one working day.
